The objective of this lab exercise is for you to configure a switch to use the Rapid Spanning Tree Protocol.
RSTP is used in preference to STP. Rather than watch a video solution, I have provided show runs and test commands where appropriate.
This lab is suitable for both ICND and CCNA certification exam preparation.
This lab has a difficulty rating of 3/10.
When you are ready for your certification exam, you should complete this lab in no more than 15 minutes.
Please use the following topology to complete this lab exercise:
Configure the topology above. Set the interfaces to trunk.
Configure VLANs 10 and 20 on both switches.
On both switches set RSTP as the protocol.
Show Runs SwitchA REFER TO THE TESTS! SwitchB REFER TO THE TESTS!
SwitchA#show spanning-tree summary Switch is in pvst mode SwitchB#show span summary Switch is in rapid-pvst mode