Lab 5-2: Establishing a Frame Relay Connection

Physical Topology Diagram Visual Topology Command Line Task 1: Setting up a basic Frame-relay link Task 2: Supporting Frame-relay using sub-interfaces Visual Topology Command Line Command Description encapsulation Frame-relay Enables Frame-relay encapsulation... Read more »

Lab 5-1: Setting up a Serial Connection

Physical Topology Diagram Visual Topology Command Line Task 1: Using HDLC Task 2: Configuring PPP Task 3: Setting up PPP authentication Visual Topology Command Line Command Description debug ppp authentication Displays the... Read more »

Lab 4-2: Implementing OSPF for IPv6

Physical Topology Diagram Visual Topology Command Line Task 1: Enabling OSPFv3 Visual Topology Command Line Command Description ipv6 ospf process id area id Enables OSPFv3 on an interface ipv6 router ospf process... Read more »

Lab 4-1: Implementing OSPF in a Multi-area Environment

Physical Topology Diagram Visual Topology Command Line Task 1: Configuring a multi-area OSPF network. Visual Topology Command List Command Description network address wildcard mask area id Specifies which interfaces are OSPF capable and... Read more »

Lab 3-2: Implementing EIGRP for IPv6

Physical Topology Diagram Visual Topology Command Line Task 1: Setting up IPv6 on the interface. Task 2: Enabling EIGRP for IPv6. Visual Topology Command List Command Description ipv6 address address / mask Applies... Read more »

Lab 3-1: Implementing EIGRP

Physical Topology Diagram Visual Topology Command List Task 1: Remote network connectivity. Task 2: Configure EIGRP Task 3: Using show commands to verify EIGRP parameters Visual Topology Command List Command Description debug eigrp... Read more »

Lab 1-3: Configuring EtherChannel

Physical Topology Diagram Visual Topology Command List Task 1: EtherChannel configuration Visual Topology Command List Command Description Channel-group id mode active Configures an interface as EtherChannel bundle members using LACP in active mode.... Read more »

Lab 1-2: Optimizing STP

Physical Topology Diagram Visual Topology Command List Task 1: Verify STP operation. Task 2: Manipulating Root Bridge selection. Task 3: Configuring Rapid Spanning-tree Task 4: Using STP Portfast. Visual Topology Command List Command... Read more »

Lab 1-1: VLANs and Trunks Connections

Physical Topology Diagram Visual Topology Command List Task 1: Reload and check that the Switch is set to factory defaults. Task 2: Basic switch set-up. Task 3: Configure basic VLAN and Trunk... Read more »