Introduction to Linux I Chapter 19 Test Online 2016

Which command is used from the command line, to edit your disk’s partition table?

If you want to initialize swap space that you’ve just created, which command would you run?

To activate a swap space that has been initialized, you can execute:

If you want to create a Fourth Extended Filesystem on a partition, which commands could you use?. (choose two)

Which of the following commands will allow you to backup a partition table to a file and restore it at a later time?

Which of the following commands will allow you to add a physical volume to an existing volume group?

After running fdisk -cu /dev/sdb, what fdisk command will allow you to list the current partition table?

After running fdisk -cu /dev/sdb, what fdisk command will allow you to change a partition type?

After running fdisk -cu /dev/sdb, what fdisk command will allow you to create a new partition?

After running fdisk -cu /dev/sdb, what fdisk command will allow you to delete a partition?

After running fdisk -cu /dev/sdb, what fdisk command will allow you to quit without saving changes?

After running fdisk -cu /dev/sdb, what fdisk command will allow you to save changes and quit?

Which command is used to create a logical volume?

Which command is used to create a volume group?

Which mke2fs option defines the block size of the filesystem?

Which mke2fs option defines the percentage of the filesystem that is reserved for system use?

What option to the fdisk command is used for MS-DOS compatibility mode?

What option to the fdisk command is used to display current partitions?

What option to the fdisk command is used to utilize sector unit sizes?

What option to the mkfs command allows you to specify the type of filesystem to create?

Which command is used to create a physical volume?