The objective of this lab exercise is for you to learn how to upgrade your Cisco router using TFTP.
Making sure that you know how to upgrade the IOS code in your Cisco device is one of the most important things a network engineer must know. As a Cisco engineer, as well as in the Cisco CCNA exam, you will be expected to know how to upgrade your Cisco IOS router. You will need another IOS available to replace the current one on your router. If you prefer to use Packet Tracer, then you will need to follow a slightly different process as show in the video.
This lab is suitable for CCENT and CCNA certification exam preparation.
This lab has a difficulty rating of 6/10.
When you are ready for your certification exam, you should complete this lab in no more than 10 minutes.
Please use the following topology to complete this lab exercise:
Configure the hostnames on router R1 as illustrated in the topology.
Configure the IP addresses on the Gig0/0 interface of R1 as illustrated in the topology.
Copy the IOS File (.bin image) from Server 1 to R1’s flash memory using the TFTP protocol. You can use free TFTP software on the server or use Packet Tracer for this lab, which has it built in.
Note: In this lab the IOS code to be uploaded to R1 is c2691-advipservicesk9-mz.124-25d.bin.
Make sure that you set the new image you just uploaded to R1 as the boot image and reboot R1.
Configuration and Verification
For reference information on configuring hostnames, please refer to earlier labs.
R1#conf t Enter configuration commands, one per line. End with CTRL/Z. R1(config)#int gig0/0 R1(config-if)#no shutdown R1(config-if)#ip add 192.168.1.1 255.255.255.0 R1(config-if)#end R1#
R1#copy tftp://192.168.1.2/c2691-advipservicesk9-mz.124-25d.bin flash:/c2691-advipservicesk9-mz.124-25d.bin
R1#conf t Enter configuration commands, one per line. End with CTRL/Z. R1(config)#boot system flash://c2691-advipservicesk9-mz.124-25d.bin R1(config)#end R1#reload
When the reboot process ends, the router will be running the new code.
Note: In the video solution, I used Packet Tracer, which will only permit the prompts after you type copy tftp: flash:, which is another way of updating the IOS. If there is insufficient room for more than one IOS, you will be prompted to erase the current IOS.