Beginning with the Cisco IOS Software Release 15.0, which license is a prerequisite for installing additional technology pack licenses? IPBase* UC DATA SEC What is the major release number in the IOS image name c1900-universalk9-mz.SPA.152-3.T.bin? 15* 52 2 1900 3 Refer to the exhibit. What does the number 17:46:26.143 represent? …
Read More »
What is the primary purpose of NAT? conserve IPv4 addresses* allow peer-to-peer file sharing enhance network performance increase network security Which method is used by a PAT-enabled router to send incoming packets to the correct inside hosts? It uses the destination TCP or UDP port number on the incoming packet. …
Read More »
Which DHCPv4 message will a client send to accept an IPv4 address that is offered by a DHCP server? unicast DHCPACK broadcast DHCPACK unicast DHCPREQUEST broadcast DHCPREQUEST* A company uses DHCP servers to dynamically assign IPv4 addresses to employee workstations. The address lease duration is set as 5 days. An …
Read More »
CCNA Routing and Switching Routing & Switching Essentials Chapter 7 SIC: VLANs, Trunking, and Router-on-a-Stick
Read More »
In which configuration would an outbound ACL placement be preferred over an inbound ACL placement? when the ACL is applied to an outbound interface to filter packets coming from multiple inbound interfaces before the packets exit the interface* when a router has more than one ACL when an outbound ACL …
Read More »
CCNA Routing and Switching Routing and Switching Essentials RSE Chapter 6 SIC Practice Skills Assessment – Packet Tracer A few things to keep in mind while completing this activity 1. Do not use the browser Back button or close or reload any exam windows during the exam 2. Do not …
Read More »
What are three primary benefits of using VLANs? (Choose three.) security* a reduction in the number of trunk links cost reduction* end user satisfaction improved IT staff efficiency* no required configuration Which type of VLAN is used to designate which traffic is untagged when crossing a trunk port? data default …
Read More »
Which statement describes the port speed LED on the Cisco Catalyst 2960 switch? If the LED is green, the port is operating at 100 Mb/s.* If the LED is off, the port is not operating. If the LED is blinking green, the port is operating at 10 Mb/s. If the …
Read More »
A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.) lower bandwidth requirements reduced cost for equipment and …
Read More »
IT Beginner IT for Beginner