Recent Posts

Lab 5-1: Configure basic IPv6

Visual Topology Command Line Command Description ipv6 address address / mask ipv6 unicast-routing ping address show ipv6 interface...

Lab 4-3: Implementing OSPF

Visual Topology Command Line Command Description Erase startup-config or Write erase Removes the startup-configuration from NVram Hostname Defines...

Lab 4-2: Using a Router to provide DHCP Services

Visual Topology Command Line Command Description default-router address dns-server address ip dhcp excluded-address ip address [last ip address]...

Lab 4-1: Enhancing a Switched Network

Visual Topology Command Line Command Description encapsulation dot1q vlan Enables IEEE 802.1Q encapsulation on a routers sub-interface no...

Lab 3-3: Using ACLs to filter IP based traffic

Visual Topology Command Line Command Description Interface loopback0 Creates an internal interface ip access-group acl name [in/out] Binds...

Lab 3-2: Device Hardening

Visual Topology Command Lis Command Description [no] cdp enable Enables or disables CDP on an interface show cdp...

Lab 3-1: Improving Device Security

Visual Topology Command Lis Command Description Access-class acl id [in/out] Access-class acl id [in/out] Access-list number permit ip...

Lab 2-2: Internet connections

Visual Topology Command Lis Command Description Access-list acl id permit network wildcard mask Creates a standard IP access...

Lab 2-1: Router startup and Initial Configuration

Visual Topology Command Lis Command Description Configure Terminal Enters global configuration mode. Copy run start Saves the dynamic...

Lab 1-2: Troubleshooting Switch Media Issues

Visual Topology Command Lis Command Description Configure Terminal Enters global configuration mode. Copy run start Saves the dynamic...