Lab 3-1: Implementing EIGRP
Physical Topology Diagram Visual Topology Command List Task 1: Remote network connectivity. Task 2: Configure EIGRP Task 3:…
-
-
Lab 1-3: Configuring EtherChannel
Physical Topology Diagram Visual Topology Command List Task 1: EtherChannel configuration Visual Topology Command List Command Description Channel-group id…
-
Lab 1-2: Optimizing STP
Physical Topology Diagram Visual Topology Command List Task 1: Verify STP operation. Task 2: Manipulating Root Bridge selection….
-
Lab 1-1: VLANs and Trunks Connections
Physical Topology Diagram Visual Topology Command List Task 1: Reload and check that the Switch is set to…
-
Lab 5-2: Configure IPv6 Routing
Visual Topology Command Line Command Description ipv6 ospf process id area id Enables OSPFv3 on the interface ipv6…
-
Lab 5-1: Configure basic IPv6
Visual Topology Command Line Command Description ipv6 address address / mask ipv6 unicast-routing ping address show ipv6 interface…
-
Lab 4-3: Implementing OSPF
Visual Topology Command Line Command Description Erase startup-config or Write erase Removes the startup-configuration from NVram Hostname Defines…
-
Lab 4-2: Using a Router to provide DHCP Services
Visual Topology Command Line Command Description default-router address dns-server address ip dhcp excluded-address ip address [last ip address]…
-
Lab 4-1: Enhancing a Switched Network
Visual Topology Command Line Command Description encapsulation dot1q vlan Enables IEEE 802.1Q encapsulation on a routers sub-interface no…
-
Lab 3-3: Using ACLs to filter IP based traffic
Visual Topology Command Line Command Description Interface loopback0 Creates an internal interface ip access-group acl name [in/out] Binds…
