ICND2 Labs

Lab 5-2: Establishing a Frame Relay Connection

Physical Topology Diagram Visual Topology Command Line Task 1: Setting up a basic Frame-relay link Task 2: Supporting Frame-relay using sub-interfaces Visual Topology Command Line Command Description encapsulation Frame-relay Enables Frame-relay encapsulation on an interface Frame-relay interface-dlci dlci Assigns a DLCI to an interface or subinterface Interface interface.subinterface point-topoint Creates …

Read More »

Lab 5-1: Setting up a Serial Connection

Physical Topology Diagram Visual Topology Command Line Task 1: Using HDLC Task 2: Configuring PPP Task 3: Setting up PPP authentication Visual Topology Command Line Command Description debug ppp authentication Displays the PPP authentication process in real time debug ppp negotiation Displays the PPP negotiation packet exchange encapsulation HDLC Enables …

Read More »

Lab 4-2: Implementing OSPF for IPv6

Physical Topology Diagram Visual Topology Command Line Task 1: Enabling OSPFv3 Visual Topology Command Line Command Description ipv6 ospf process id area id Enables OSPFv3 on an interface ipv6 router ospf process id Enters the OSPFv3 configuration mode router-id id Set a 32 bit router-id (dotted decimal notation) Show ipv6 …

Read More »

Lab 4-1: Implementing OSPF in a Multi-area Environment

Physical Topology Diagram Visual Topology Command Line Task 1: Configuring a multi-area OSPF network. Visual Topology Command List Command Description network address wildcard mask area id Specifies which interfaces are OSPF capable and links them to an OSPF area router ospf process id Enters the OSPF router configuration mode show ip …

Read More »

Lab 3-2: Implementing EIGRP for IPv6

Physical Topology Diagram Visual Topology Command Line Task 1: Setting up IPv6 on the interface. Task 2: Enabling EIGRP for IPv6. Visual Topology Command List Command Description ipv6 address address / mask Applies an IPv6 address to an interface ipv6 eigrp AS number Configures EIGRP for IPv6 on an interface ipv6 …

Read More »

Lab 3-1: Implementing EIGRP

Physical Topology Diagram Visual Topology Command List Task 1: Remote network connectivity. Task 2: Configure EIGRP Task 3: Using show commands to verify EIGRP parameters Visual Topology Command List Command Description debug eigrp neighbors Debugs eigrp events network network [wildcard mask] Enables the routing protocol on the interfaces, an optional wildcard …

Read More »

Lab 1-3: Configuring EtherChannel

Physical Topology Diagram Visual Topology Command List Task 1: EtherChannel configuration Visual Topology Command List Command Description Channel-group id mode active Configures an interface as EtherChannel bundle members using LACP in active mode. Channel-group id mode passive Configures an interface as EtherChannel bundle members using LACP in passive mode. Configure Terminal …

Read More »

Lab 1-2: Optimizing STP

Physical Topology Diagram Visual Topology Command List Task 1: Verify STP operation. Task 2: Manipulating Root Bridge selection. Task 3: Configuring Rapid Spanning-tree Task 4: Using STP Portfast. Visual Topology Command List Command Description Configure Terminal Enters global configuration mode. Copy run start Saves the dynamic running-config to NVRAM. [no] debug …

Read More »

Lab 1-1: VLANs and Trunks Connections

Physical Topology Diagram Visual Topology Command List Task 1: Reload and check that the Switch is set to factory defaults. Task 2: Basic switch set-up. Task 3: Configure basic VLAN and Trunk connections. Task 4: Troubleshoot Trunk failure. Visual Topology Command List Command Description Configure Terminal Enters global configuration mode Copy …

Read More »