Lab 5-2: Establishing a Frame Relay Connection

Physical Topology Diagram Visual Topology Command Line Task 1: Setting up a basic Frame-relay link Task 2: Supporting Frame-relay using sub-interfaces Visual Topology Command Line Command Description encapsulation Frame-relay Enables Frame-relay encapsulation... Read more »

Lab 5-1: Setting up a Serial Connection

Physical Topology Diagram Visual Topology Command Line Task 1: Using HDLC Task 2: Configuring PPP Task 3: Setting up PPP authentication Visual Topology Command Line Command Description debug ppp authentication Displays the... Read more »

Lab 4-2: Implementing OSPF for IPv6

Physical Topology Diagram Visual Topology Command Line Task 1: Enabling OSPFv3 Visual Topology Command Line Command Description ipv6 ospf process id area id Enables OSPFv3 on an interface ipv6 router ospf process... Read more »

Lab 4-1: Implementing OSPF in a Multi-area Environment

Physical Topology Diagram Visual Topology Command Line Task 1: Configuring a multi-area OSPF network. Visual Topology Command List Command Description network address wildcard mask area id Specifies which interfaces are OSPF capable and... Read more »

Lab 3-2: Implementing EIGRP for IPv6

Physical Topology Diagram Visual Topology Command Line Task 1: Setting up IPv6 on the interface. Task 2: Enabling EIGRP for IPv6. Visual Topology Command List Command Description ipv6 address address / mask Applies... Read more »

Lab 3-1: Implementing EIGRP

Physical Topology Diagram Visual Topology Command List Task 1: Remote network connectivity. Task 2: Configure EIGRP Task 3: Using show commands to verify EIGRP parameters Visual Topology Command List Command Description debug eigrp... Read more »

Lab 1-3: Configuring EtherChannel

Physical Topology Diagram Visual Topology Command List Task 1: EtherChannel configuration Visual Topology Command List Command Description Channel-group id mode active Configures an interface as EtherChannel bundle members using LACP in active mode.... Read more »

Lab 1-2: Optimizing STP

Physical Topology Diagram Visual Topology Command List Task 1: Verify STP operation. Task 2: Manipulating Root Bridge selection. Task 3: Configuring Rapid Spanning-tree Task 4: Using STP Portfast. Visual Topology Command List Command... Read more »

Lab 1-1: VLANs and Trunks Connections

Physical Topology Diagram Visual Topology Command List Task 1: Reload and check that the Switch is set to factory defaults. Task 2: Basic switch set-up. Task 3: Configure basic VLAN and Trunk... Read more »

Lab 5-2: Configure IPv6 Routing

Visual Topology Command Line Command Description ipv6 ospf process id area id Enables OSPFv3 on the interface ipv6 router ospf process id Enters OSPFv3 router configuration mode Ping address Checks end to... Read more »